How To Pick The Best Steering Wheel

Featured

The steering wheel leather covers not only protect the steering wheel against daily wear or sun damage but also greatly improve the driving experience by providing excellent grip for better handling.

First, take the leather steering wheel cover and extend it to the entire steering wheel. Make sure the temperature in your car is not too hot or cold, as the skin moves easily in hot climates and becomes less flexible in cold climates. Place the cap on the bottom of the steering wheel and extend it to the sides. Do not forget to use your fingers to spread it over the top of the wheel. At this point, you must be careful not to touch the seam firmly, where you can easily break it. Check it twice to see if it is carefully aligned so that it is perfectly in the place where it is supposed to be. This is usually above the previous sewing site, but you may want to have a little more forward or backwards. Consistency is important here because a seam that can cause it to be installed inside the edge of the installation process is more difficult. A quick tip is to reduce the torque during your run so you can pull evenly from the front and back.

Carefully cut the remaining thread to about a quarter of an inch, but make sure it is not too close. Be sure to use the corresponding holes directly from each other. To start stitching, be sure to cross the thread and under the seam, as well as undo the other side. The important thing to keep in mind is that you will have to cross the threads, in the same way, every time.

I have already reached the first to speak at the wheel. To cross the spokes of the wheel, use the seam loop through the loop around the thread and at the next hole on both sides of the spoke wheel. Pull each stitch as hard as possible with a constant and constant pull. Do not worry about breaking the tarp, as it is designed to require a lot of abuse. After reaching the other side of the steering wheel, lift the next pair of holes that you can close almost completely.

If the size of the leather wheel cover is correct, it will not stretch too long if you continue sewing. There will be few hits, but this is normal in the installation process. Once you reach the bottom again, hold the last stitches and shake them repeatedly underneath the original node while running the seam. After that, you should hook several knots and then cut off the excess seam. Be sure to leave at least a half-inch of a pagan knot stuck in the seam.  This guest post was bought to you by Ozzy Tyres Australia.